[brussels-dev] strange dladm show-ether output

[Sebastien Roy]

Folks,

What should I make of the following dladm show-ether output on 
snst-router.east?

# dladm show-ether
LINK            PTYPE    STATE    AUTO  SPEED-DUPLEX 
PAUSE
eth0            current  unknown  yes   1G-u                            none
eth1            current  unknown  yes   1G-u                            none
eth2            current  unknown  yes   1G-u                            none
eth3            current  unknown  yes   1G-u                            none
# dladm show-phys
LINK         MEDIA                STATE      SPEED DUPLEX   DEVICE
eth0         Ethernet             up         1000 full      nge0
eth1         Ethernet             up         1000 full      nge1
eth2         Ethernet             up         1000 full      e1000g0
eth3         Ethernet             up         1000 full      e1000g1

Why is STATE different in these two commands, and what does 1G-u mean 
for SPEED-DUPLEX in show-ether?

-Seb