[ldoms-discuss] Future of LDOMs, and welcome!

[Tommy McNeely]

IN response to #3, Can you maybe do LAG/LACP?

Take a look at dladm, it creates an aggregate interface that support (primitave) load balancing and fail over. 

# dladm create-aggr -l active -d e1000g0 -d e1000g1 1

# dladm show-aggr
key: 1 (0x0001) policy: L4      address: 0:14:4f:82:55:be (auto)
           device       address                 speed           duplex  link    state
           e1000g0      0:14:4f:82:55:be          1000  Mbps    full    up      attached
           e1000g1      0:14:4f:82:55:bf          1000  Mbps    full    up      attached


# ldm ls-bindings primary
Name:   primary
State:  active
Flags:  normal,control,vio service
OS:     Solaris running
Util:   0.7%
Uptime: 1d 16h 48m
[snip]
Vsw:    my-infrasvc-vsw
                mac-addr=0:14:4f:f8:82:d9
                net-dev=aggr111001
                mode=prog,promisc
Vsw:    my-admin-vsw
                mac-addr=0:14:4f:f9:30:57
                net-dev=aggr110001
        [LDC: 0xe]
        [LDom hrc-admin-global, name: vnet1, mac-addr: 0:14:4f:fa:f:43]
                mode=prog,promisc
[snip]


In this case I have an interface "aggr1" that is both e1000g0 and e1000g1. Each interface is plugged into a different blade of my force 10 switch with LACP enabled on the ports. I have interfaces on vlan 110 and vlan 111 using 802.1q vlan tagging on the switch.

Tommy
--
This message was posted from opensolaris.org