[ug-hosug] connecting to internet

Raju Alluri spurthi at gmail.com
Sun Mar 2 17:29:47 PST 2008


BSNL offters a PPPoE service and you need to configure your system for that.
It is very simple to do it on OpenSolaris.

The following post explains the steps:
   http://forum.java.sun.com/thread.jspa?threadID=5218759&tstart=30
Note that if you have installed recent opensolaris, then you don't need to install the packages mentioned there. They are already part of your system.

Let me know if you end up with any issues.

Regards,
- Raju


> Hi,
> I have installed Solaris 10 on my PC.MotherBoard is
> intel D865GSA and On board LAN Card of realtek
> 8139.All drivers are installed.
> I have internet connection of VSNL Broadband with
> DHCP.They have provided me router.I don't know their
> IP address.
> I executed the sys-unconfig and answered as
> follwows.
> 
> select a language -- 0(English)
> select a locale --0 (English)
> key board layout --US-English
> Networked -- yes
> use DHCP for rtls0-- yes
> enable IPv6 for rtls0-- no
> configure kerberos Security --no
> Name Service -- None
> NFSv4 Domain Configuration -- use the NFSv4 domain
> derived by the system
> 
> and so on..
> it further asked my root password, date time settings
> etc.
> What went wrong in above mentioned steps?
> 
> Do I need to contact my ISP to get it's IP address?
> 
> further I executed ifconfig and netstat.The results
> were as follows.
> 
> # ifconfig -a
> lo0: flags=2001000849 mtu 8232 index 1
> inet 127.0.0.1 netmask ff000000
> rtls0: flags=1004843 mtu 1500 index 2
> inet 192.168.1.100 netmask ffffff00 broadcast
> 192.168.1.255
> ether 0:16:76:84:7b:b0
> # netstat -nr
> 
> Routing Table: IPv4
> Destination Gateway Flags Ref Use Interface
> -------------------- -------------------- ----- -----
> ---------- ---------
> default 192.168.1.254 UG 1 0 rtls0
> 192.168.1.0 192.168.1.100 U 1 1 rtls0
> 224.0.0.0 192.168.1.100 U 1 0 rtls0
> 127.0.0.1 127.0.0.1 UH 12 482 lo0
> #
> 
> Still Ping doesn't work.
> Do I need to configure DNS? Which values should I use
> over there?
> Do I need to make any changes in the configuration?
> 
> Thanking You!
> 
> Prashant Poman.
--
This messages posted from opensolaris.org


More information about the ug-hosug mailing list